IS903 Controller USB FLASH DRIVE PCBA, Support LGA60 / LGA52 Dual Pads Flash Memory, IS903 Controller USB3.0 PCBA, DIY UFD PCBA for LGA60 LGA52 Flash.

USB 3.0 IS903 Controller USB FLASH DRIVE PCBA DIY LGA60 LGA52 Flash

Host: USB3.0
Controller: IS903
Solder Pads: LGA60 /LGA52
notes : Single-chip mounted  must be on the same side of the controller. Dual-chip mounted, the Part Number of NAND Flash must be of the same type.
Notes: Single-Mounted NAND Flash  (mounted on the same side of the controller)   work in Single-Channel mode ,and Dual-Mounted NAND Flash work in Dual-Channel mode. 
 

IS903 Controller IC:
 

1. 
IS903 is the USB-3.0 interface Nand Flash Controller. With flexible firmware code supporting, IS903 can support various
flash technology including 8k / 16k page SLC / MLC by different 2xnm / 2ynm / 1xnm process for major flash vendors.

2. Features

Flash support 2xnm, 2ynm, 1xnm process Flash from various vendors One Channel / two channel data bus by small footprint package Up to 4 CEs per channel to support max. 8 Flash CEs SLC / MLC types Nand Flash supported ONFI 2.1 spec. interface supported Toggle DDR interface supported USB interface Compliant with USB 3.0 spec. version 1.0, Compliant with USB 2.0 spec. backward compatible with USB1.1,

Compliant with USB Mass Storage Class spec. version 1.0 ECC protect 43 bit by 1K bytes High performance 1T 8051 with hardware acceleration DMA F/W off-load engine embedded 1.2V low power consumption design LED indicator to show link status and r/w traffic Customized VID/ PID with serial number 30Mhz Crystal